Скутер cpi gtr 50 инструкция пользователя

Remove the spark plug cap. Do not let the clip fall into the crankcase. Remove the piston pin. Clean the grooves for carbon deposit completely. Install the piston ring.

Install the oil seal into the left crankcase. Install the right crankcase. Install the oil seal into the right crankcase. Install the setting bolts of crankcase. Remove the side covers. Remove the cylinder air should. Remove the fly wheel by using a pulley. Connect the charge negative - cable to the battery negative - terminal.

Loose the carburetor cap of throttle valve. Remove the throttle valve from the throttle cable. Check the current of air route as show. Remove the intake pipe. Remove the reed valve. Please have a protected pad on the proper location of the ground to avoid crash or damage of plastic parts.

Open and remove the seat. Remove the rear luggage case. Remove the side cover. Remove the throttle valve from the carburetor. Disconnect the earth wire of engine. Disconnect the coil wire. Disconnect the spark plug cap. Disconnect the rear brake cable. Remove the setting bolt of rear cushion. Remove the setting bolt of engine. Remove the oil pump control cable.

Drain the gear oil Remove the mission cover. Remove the right crankcase from the left crankcase by using a pulley. Remove the crankcase from the left crankcase by using a pulley. Remove the bearing of crankcase by using a bearing pulley. Install the crankshaft bearing into the right crankcase. Install the crankshaft into the left crankcase.

Mark connections with an ohmmeter as shown. The coil is normal if there is continuity. Mileages are expressed in terms of kilometers and months. For the front fork ii. For the brake sensor 2. Page of 43 Go. Was This Manual Helpful? Comments to this Manuals Your Name. Enter text from picture: To print the manual completely, please, download it. Got it, continue to print.

Remove the setting bolt of oil pump. Remove the oil pump. Let the oil drain out in smoothly then tight the screw. If the oil can not drain out in smoothly, it is mean some air still in the oil pump. Remove the luggage box.

Avoid piston and piston ring damage during installation. All ring should be installed with the mark facing up. Coat the cylinder and piston ring with the engine oil. Worm up the engine before test. Remove the crankcase cover. Remove the dowel pin. Remove the kick pinion with the kick friction spring. Disconnect the kick start spring. Remove the drive belt. Remove the setting nut of driver face. Remove the gear boss. Remove the plat washer. Remove the idle gear plate. Remove the idle gear. Remove the driven plat assy.